Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Front Side)

WASHER MOTOR (for Front Side) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT FENDER LINER RH


    E187035E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.



    E187036
  1. Remove the 10 clips and 4 screws.

  1. Using a clip remover, remove the grommet and the front fender liner RH.

    HINT:
    The grommet needs to be replaced with new one because it will break when it is removed.



3. DRAIN WASHER FLUID


    E187040
  1. Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.



4. REMOVE FRONT WASHER MOTOR AND PUMP ASSEMBLY


    E190069
  1. Disconnect the connector.

  1. Remove the windshield washer motor and pump assembly.