Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH

REAR POWER WINDOW SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE DOOR ASSIST GRIP COVER


    B228789
  1. Using a moulding remover, disengage the 6 claws, 2 clips and 3 guides, and remove the door assist grip cover.



2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    B228793
  1. Disengage the 7 claws and 2 guides.

  1. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.



3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B229118
  1. Disengage the 2 claws and remove the rear power window regulator switch assembly.