Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › NAME PLATE

NAME PLATE > REMOVAL

for Preparation Click here


HINT:
When removing the name plates or emblems, heat the vehicle body and name plates using a heat light.
Heating Temperature 
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Name Plate or emblem
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body, name plates or emblems excessively.



1. REMOVE LUGGAGE COMPARTMENT DOOR EMBLEM


    B229368E01
  1. Put protective tape around the luggage component door emblem.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, disengage the 3 claws and pin and remove the luggage component door emblem.

    NOTICE:
    1. If reusing the emblem, take care not to damage the luggage component door emblem.
    2. Be careful not to damage the vehicle body.



2. REMOVE NO. 2 BACK DOOR NAME PLATE


    B229371E01
  1. Put protective tape around the No. 2 back door name plate.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, peel off the double-sided tape and disengage the 2 pins to remove the No. 2 back door name plate.

    NOTICE:
    1. If reusing the name plate, take care not to damage the No. 2 back door name plate.
    2. Be careful not to damage the vehicle body.



3. REMOVE BACK DOOR NAME PLATE


    B229375E01
  1. Put protective tape around the back door name plate.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, peel off the double-sided tape and disengage the 2 pins to remove the back door name plate.

    NOTICE:
    1. If reusing the emblems, take care not to damage the back door name plate.
    2. Be careful not to damage the vehicle body.



4. REMOVE SIDE PANEL EMBLEM


    B229364E01
  1. Put protective tape around the side panel emblem.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, peel off the double-sided tape and disengage the 2 pins to remove the side panel emblem.

    NOTICE:
    1. If reusing the name plate, take care not to damage the side panel emblem.
    2. Be careful not to damage the vehicle body.

    HINT:
    Use the same procedure for the RH side and LH side.