Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE HEADLIGHT CLEANER WASHER NOZZLE COVER (w/ Headlight Cleaner System)


    E239907E01
  1. Extend the headlight cleaner washer nozzle cover.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, disengage the 2 claws and remove the headlight cleaner washer nozzle cover.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the RH side and LH side.



2. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)


    E239909E01
  1. Disconnect the headlight cleaner hose.
    Text in Illustration 
    *1
    No. 3 Headlight Cleaner Clamp
    *2
    Headlight Cleaner Hose

  1. Remove the No. 3 headlight cleaner clamp.



    E239911E01
  1. Pull down the No. 1 headlight cleaner clamp.
    Text in Illustration 
    *1
    No. 1 Headlight Cleaner Clamp



    E239913E01
  1. Pushing the tab and disengage the 2 claws and remove the headlight washer actuator sub-assembly LH as shown in the illustration.
    Text in Illustration 
    *1
    Tab



3. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)

HINT:
Use the same procedure for the RH side and LH side.



4. REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY LH (w/o Daytime Running Light)


    E238379
  1. Disconnect the connector.

  1. Disengage each clamp.

  1. Remove the clip.

  1. Using a screwdriver, disengage the 2 claws and remove the front turn signal light assembly.



5. REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY RH (w/o Daytime Running Light)

HINT:
Use the same procedure for the RH side and LH side.



6. REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY LH (w/ Daytime Running Light)


    E238383
  1. Disconnect the connector.

  1. Disengage each clamp.

  1. Remove the clip.

  1. Using a screwdriver, disengage the 2 claws and remove the front turn signal light assembly.



7. REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY RH (w/ Daytime Running Light)

HINT:
Use the same procedure for the RH side and LH side.



8. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)


    E235355
  1. Disconnect the connector.

  1. Remove the screw.

  1. Disengage the 2 guides and remove the fog light assembly.



9. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedure for the RH side and LH side.



10. REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET


    B299340
  1. Remove the 2 screws.

  1. Disengage the 2 claws and remove the front bumper extension mounting bracket.



11. REMOVE HOOD TO FRONT END PANEL SEAL


    B294740E01
  1. Remove the clip.
    Text in Illustration 
    *1
    Double-sided Tape

  1. Disengage the 2 clips and remove the hood to front end panel seal.



12. REMOVE ENGINE ROOM NO. 3 WIRE


  1. w/o Fog Light:



      B299341
    1. Disengage the 7 clamps and remove the engine room No. 3 wire.



  1. w/ Fog Light:



      B294741
    1. Disengage the 9 clamps and remove the engine room No. 3 wire.



13. REMOVE HEADLIGHT CLEANER HOSE (w/ Headlight Cleaner System)


    B299342
  1. Disengage the 8 clamps and remove the headlight cleaner hose.



14. REMOVE RADIATOR GRILLE


    B294742
  1. Remove the 4 clips.



    B294743
  1. Disengage the 12 claws and remove the radiator grille.



15. REMOVE RADIATOR GRILLE EMBLEM ASSEMBLY


    B294744
  1. Remove the 2 screws.

  1. Disengage the 4 claws and 2 pins, and remove the radiator grille emblem assembly.



16. REMOVE FRONT FENDER LINER RETAINER


    B294745
  1. Disengage the claw and remove the front fender liner retainer.

    HINT:
    Use the same procedure for the RH side and LH side.



17. REMOVE FRONT BUMPER HOLE COVER LH


    B294746E01
  1. Disengage the 3 claws.
    Text in Illustration 
    *1
    Hook

  1. Disengage the hook and remove the front bumper hole cover LH.



18. REMOVE FRONT BUMPER HOLE COVER RH

HINT:
Use the same procedure for the RH side and LH side.



19. REMOVE NO. 2 LOWER RADIATOR GRILLE


    B294747
  1. Remove the 2 screws.



    B294748
  1. Disengage the 5 claws and pin, and remove the No. 2 lower radiator grille.



20. REMOVE NO. 1 LOWER RADIATOR GRILLE


    B294749
  1. Remove the 2 outside moulding retainers.

  1. Disengage the 20 claws and remove the No. 1 lower radiator grille.



21. REMOVE FRONT BUMPER ENERGY ABSORBER


    B299343
  1. Disengage the 2 guides and remove the front bumper energy absorber.



22. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    B299344
  1. Disengage the 7 clamps.

  1. Remove the 6 bolts.

  1. Disengage the claw and remove the front bumper reinforcement sub-assembly.



23. REMOVE FRONT BUMPER SIDE SUPPORT LH


    B294753E01
  1. Remove the bolt and screw.
    Text in Illustration 
    *1
    Bolt
    *2
    Screw

  1. Disengage the 2 claws and remove the front bumper side support LH.



24. REMOVE FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure for the RH side and LH side.



25. REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY LH


    B228467
  1. Remove the 4 bolts.

  1. Disengage the guide and remove the front side member bracket sub-assembly LH.



26. REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.