Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE

CAMSHAFT OIL CONTROL VALVE > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


    A186577E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    If the result is not as specified, replace the oil control valve assembly.



  1. Check the operation.



      A160184E05
    1. Connect a positive (+) battery lead to terminal 1 and a negative (-) lead to terminal 2, and check the movement of the valve.
      Text in Illustration 
      *1
      When Applied
      *2
      When Cut Off

      NOTICE:
      Confirm that the valve moves freely and does not stick in any position.

      If necessary, replace the camshaft timing oil control valve assembly.

      HINT:
      Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be set.