BACK DOOR COURTESY SWITCH > INSTALLATION |
| 1. INSTALL BACK DOOR LOCK ASSEMBLY |
Apply MP grease to the sliding parts of the back door lock assembly.
![]() |
Install the back door lock assembly with the 3 bolts.
![]() |
Engage the 4 clamps and connect the connector.
| 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH |
Connect the connector.
Engage the 7 claws and 2 clips.
Install the deck trim side panel assembly LH with the screw.

| 3. INSTALL TONNEAU COVER HOLDER CAP |
![]() |
Engage the claw to install the tonneau cover holder cap.
| 4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY |
![]() |
Engage the 2 guides.
Install the 2 luggage hold belt striker assemblies with the 2 bolts.
| 5. INSTALL REAR DECK TRIM COVER |
![]() |
Engage the 4 claws and 4 guides to install the rear deck trim cover.
| 6. INSTALL DECK TRIM SERVICE HOLE COVER |
![]() |
Engage the 3 guides.
Engage the 2 claws to install the deck trim service hole cover.
| 7. INSTALL REAR NO. 1 FLOOR BOARD |
![]() |
Engage the 2 claws and 2 clips.
Install the rear No. 1 floor board with the bolt.
| 8. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Engage the claw and 2 clips to install the rear No. 2 floor board sub-assembly.
| 9. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Engage the 2 claws and 2 clips to install the rear No. 1 floor board sub-assembly.
| 10. INSTALL DECK FLOOR BOX LH |
![]() |
Engage the 2 guides.
Install the deck floor box LH with the clip.
| 11. INSTALL REAR NO. 4 FLOOR BOARD |
![]() |
Engage the guide to install the rear No. 4 floor board.
| 12. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Install the tonneau cover assembly.
| 13. INSTALL REAR SIDE SEATBACK ASSEMBLY LH |
![]() |
Engage the 2 guides as shown in the illustration.
Install the rear side seatback assembly LH with the bolt.
| 14. INSTALL REAR SEAT CUSHION ASSEMBLY |
![]() |
Engage the 2 guides of the seat cushion to the seatback.
| *1 | Guide |
| *2 | Hook |
Engage the 2 front hooks of the seat cushion to the vehicle body.
| 15. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Align the alignment mark (Red) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
| *1 | Alignment Mark (Red) |
| 16. INSTALL REAR DOOR SCUFF PLATE LH |
![]() |
Engage the 7 claws to install the rear door scuff plate LH.
| 17. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 18. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.