DOOR CONTROL RECEIVER > REMOVAL |
| 1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 2. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 3. REMOVE REAR DOOR SCUFF PLATE RH |
| 4. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH |
| 5. REMOVE REAR SIDE SEATBACK ASSEMBLY RH |
![]() |
Remove the bolt.
![]() |
Disengage the 2 guides and remove the rear side seatback assembly RH as shown in the illustration.
| 6. REMOVE REAR SEAT CUSHION ASSEMBLY |
![]() |
Disengage the 2 front hooks of the seat cushion from the vehicle body as shown in the illustration.
| *1 | Hook |
| *2 | Guide |
| *a | 100 mm (3.94 in.) or less |
Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.
Repeat the above procedure for the other hook.
Disengage the 2 guides of the seat cushion from the seatback.
Remove the rear seat cushion assembly.
| 7. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Remove the tonneau cover assembly.
| 8. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 9. REMOVE REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Disengage the 2 claws and 2 clips, and remove the rear No. 1 floor board sub-assembly.
| 10. REMOVE REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Disengage the claw and 2 clips, and remove the rear No. 2 floor board sub-assembly.
| 11. REMOVE REAR NO. 1 FLOOR BOARD |
![]() |
Remove the bolt.
Disengage the 2 claws and 2 clips, and remove the rear No. 1 floor board.
| 12. REMOVE DECK TRIM SERVICE HOLE COVER |
![]() |
Disengage the 2 claws and 3 guides, and remove the deck trim service hole cover.
| 13. REMOVE REAR DECK TRIM COVER |
![]() |
Disengage the 4 claws and 4 guides, and remove the rear deck trim cover.
| 14. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY |
| 15. REMOVE TONNEAU COVER HOLDER CAP |
| 16. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH |
Remove the screw.
Disengage the 7 claws and 2 clips, and remove the deck trim side panel assembly RH.

| 17. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH |
| 18. REMOVE DOOR CONTROL RECEIVER |
![]() |
Disconnect the connector.
Remove the bolt and door control receiver.