Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SWITCH ASSEMBLY

SLIDING ROOF SWITCH ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE ROOF TOP MOULDING (w/o Lane Keeping Assist System)


    B227832
  1. Using a moulding remover, disengage the 3 claws and 2 clips, and remove the roof top moulding.



2. REMOVE ROOF TOP MOULDING (w/ Lane Keeping Assist System)


    B232400E01
  1. Disengage the claw <A> as shown in the illustration.

  1. Disengage the 2 claws <B> as shown in the illustration.



    B232399
  1. Disengage the 3 claws and remove the roof top moulding.



3. REMOVE MAP LIGHT ASSEMBLY


    E189671
  1. Disengage the 4 clips and 2 guides as shown in the illustration.

  1. Disconnect the connector and remove the map light assembly.