Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Front Side)

WASHER NOZZLE (for Front Side) > INSTALLATION

for Preparation Click here



1. INSTALL WASHER NOZZLE SUB-ASSEMBLY


    E189326
  1. Connect a new washer nozzle sub-assembly to the washer hose.



    E189324E01
  1. Engage the 2 claws and install the washer nozzle sub-assembly as shown in the illustration.



2. INSPECT WASHER NOZZLE SUB-ASSEMBLY


  1. With the engine running, check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E189307E01


    Standard Clearance 
    Area
    Measurement
    A
    443.7 mm (17.5 in.)
    B
    546.6 mm (21.5 in.)
    C
    208.2 mm (8.20 in.)
    D
    82.1 mm (3.23 in.)

    Text in Illustration 
    *1
    Upper Limit
    *2
    Standard
    *3
    Lower Limit
    -
    -

    HINT:
    If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.



3. ADJUST WASHER NOZZLE SUB-ASSEMBLY


  1. Select a washer nozzle so that the contact area is within the standard. Replace the washer nozzle with the selected one.


    E239459E02


    Text in Illustration 
    *a
    Available Washer Nozzles
    *b
    Washer Fluid Spray Angle
    *c
    Part Number
    -
    -