BACK DOOR OUTSIDE GARNISH > REMOVAL |
| 1. REMOVE BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Using a moulding remover, disengage the clip and claw.
![]() |
Using a moulding remover, disengage the clip and claw.
![]() |
Disengage the 3 clips in the order shown in the illustration.
![]() |
Disengage the 2 clips by pulling the back door trim board assembly in the direction indicated by the arrows in the illustration.
![]() |
Remove the back door trim board assembly by pulling it in the direction indicated by the arrow in the illustration to disengage the 4 clips.
| *1 | Back Door Trim Board Assembly |
| *2 | Back Door Panel |
| *a | The portion that may be damaged due to interference |
| 2. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY |
![]() |
Put protective tape around the back door outside garnish sub-assembly.
| *1 | Protective Tape |
![]() |
Remove the 4 nuts.
![]() |
Disengage the 11 clips and remove the back door outside garnish sub-assembly.
Remove the 11 clips (back door outside garnish clip) from the back door outside garnish sub-assembly.
Remove the 4 gaskets from the back door outside garnish sub-assembly.
| 3. REMOVE BACK DOOR OPENER SWITCH ASSEMBLY |
![]() |
Remove the back door opener switch assembly.
| 4. REMOVE LUGGAGE COMPARTMENT DOOR EMBLEM |
![]() |
Put protective tape around the luggage component door emblem.
| *1 | Protective Tape |
Using a moulding remover, disengage the 3 claws and pin and remove the luggage component door emblem.
| 5. REMOVE NO. 2 BACK DOOR NAME PLATE |
![]() |
Put protective tape around the No. 2 back door name plate.
| *1 | Protective Tape |
Using a moulding remover, peel off the double-sided tape and disengage the 2 pins to remove the No. 2 back door name plate.
| 6. REMOVE BACK DOOR NAME PLATE |
![]() |
Put protective tape around the back door name plate.
| *1 | Protective Tape |
Using a moulding remover, peel off the double-sided tape and disengage the 2 pins to remove the back door name plate.