Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZE FUNCTION WITH TECHSTREAM

NOTICE:
  1. Be sure to record the current settings before customizing.
  2. These buzzers should be ON for safe driving. Perform this procedure only if it is necessary to set the buzzer to OFF (disabled).

HINT:
The following items can be customized using the Techstream.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Combination Meter / Utility / Customize Setting.

  5. Select the setting by referring to the table below.

    Combination Meter 
    Tester Display
    Default
    Content
    Setting
    Driver Side Seatbelt Warning Buzzer
    ON
    Function to sound the seat belt warning buzzer
    ON/OFF
    Front Passenger Side Seatbelt Warning Buzzer
    ON
    Function to sound the seat belt warning buzzer
    ON/OFF

    HINT:
    This setting is only valid when the vehicle is driven at 20 km/h (12 mph) or more.