GLOVE BOX LIGHT > REMOVAL |
| 1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Using a moulding remover, slightly lift the panel at the position shown in the illustration.
| *a | Lift slightly |
Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.
Disconnect each connector and remove the integration control and panel assembly.
| 2. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.
![]() |
Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.
| 3. REMOVE NO. 1 SIDE DEFROSTER NOZZLE |
![]() |
Using a moulding remover, slightly lift the panel at the position shown in the illustration.
| *a | Lift slightly |
Pull the No. 1 side defroster nozzle in the direction indicated by the arrow to disengage the 3 claws and remove the No. 1 side defroster nozzle.
| 4. REMOVE NO. 2 INSTRUMENT PANEL REGISTER |
![]() |
Pull the No. 2 instrument panel register in the direction indicated by the arrow to disengage the claw and clip.
![]() |
Pull the No. 2 instrument panel register in the direction indicated by the arrow to disengage the 2 claws and remove the No. 2 instrument panel register.
| 5. REMOVE GLOVE COMPARTMENT DOOR |
Open the glove compartment door assembly.
![]() |
Pull the glove compartment door in the direction indicated by the arrow to disengage the 7 claws.
Pull the glove compartment door in the direction indicated by the arrow to remove the glove compartment door.
| 6. REMOVE GLOVE BOX LIGHT ASSEMBLY |
![]() |
Disconnect the connector.
Using a screwdriver, disengage the 2 claws and remove the glove box light assembly.