Home › Vehicle Exterior › LIGHTING (EXT) › HIGH MOUNTED STOP LIGHT ASSEMBLY

HIGH MOUNTED STOP LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE UPPER BACK DOOR TRIM PANEL ASSEMBLY


    B227895
  1. Using a moulding remover, disengage the 4 clips and 4 claws, and remove the upper back door trim panel assembly.



2. REMOVE BACK DOOR SIDE GARNISH RH


    B227897
  1. Disengage the 3 clips and 2 claws, and remove the back door side garnish RH.



3. REMOVE BACK DOOR SIDE GARNISH LH


    B227898
  1. Disengage the 3 clips and 2 claws, and remove the back door side garnish LH.



4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B227899
  1. Using a moulding remover, disengage the clip and claw.



    B227900
  1. Using a moulding remover, disengage the clip and claw.



    B257325E01
  1. Disengage the 3 clips in the order shown in the illustration.



    B257326
  1. Disengage the 2 clips by pulling the back door trim board assembly in the direction indicated by the arrows in the illustration.



    B257327E01
  1. Remove the back door trim board assembly by pulling it in the direction indicated by the arrow in the illustration to disengage the 4 clips.
    Text in Illustration 
    *1
    Back Door Trim Board Assembly
    *2
    Back Door Panel
    *a
    The portion that may be damaged due to interference

    NOTICE:
    Make sure to pull the back door trim board assembly in the direction indicated by the arrow in the illustration. If the back door trim board assembly is removed from the lower part, the door pull handle mounting area may interfere with the back door panel, resulting in damage to the back door trim board assembly.



5. REMOVE BACK DOOR TRIM BOARD


    B227903
  1. Disengage the 5 clips and 2 guides, and remove the back door trim board.



6. REMOVE REAR SPOILER ASSEMBLY


    B228492
  1. Disconnect the connector.

  1. Remove the 5 nuts.



    B228493
  1. Disengage the 2 clips to remove the rear spoiler assembly.



7. REMOVE CENTER STOP LIGHT SET


    E195090E01
  1. Secure a wire around the center stop light set wire harness as shown in the illustration.
    Text in Illustration 
    *1
    Wire

    NOTICE:
    Use a wire long enough so that the center stop light set wire harness can be passed through the rear spoiler assembly during installation.

  1. Remove the 2 screws.



    E195091E01
  1. Place a cloth on the rear spoiler assembly as shown in the illustration.
    Text in Illustration 
    *1
    Wire Harness
    *2
    Gasket
    *3
    Wire
    *4
    Protective Tape
    *5
    Cloth

  1. Using a clip remover wrapped with protective tape, widen the space inside the rear spoiler assembly, and pull the center stop light set wire harness to remove it as shown in the illustration.

    NOTICE:
    1. Do not apply excess force to the rear spoiler assembly or it may be damaged.
    2. Do not damage the gasket of the rear spoiler assembly.
    3. Do not apply excess force when pulling the wire harness or it may break.

  1. Remove the wire from the old center stop light set wire harness.