Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY

HINT:
Refer to the procedure up to Remove Upper Instrument Panel Assembly (Click here).



2. REMOVE NO. 3 SIDE DEFROSTER NOZZLE DUCT


    E189204
  1. Remove the clip and No. 3 side defroster nozzle duct.



3. REMOVE TURN SIGNAL FLASHER ASSEMBLY


    E189665
  1. Using a screwdriver, disengage the claw.

  1. Disconnect the connector and remove the turn signal flasher assembly.