Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR COMBINATION LIGHT BODY GASKET


    E235372
  1. Remove the rear combination light body gasket.

    NOTICE:
    1. Be sure to remove all the traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light body gasket to prevent water ingress.



2. REMOVE REAR TURN SIGNAL LIGHT BULB


    E235373
  1. Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration and disconnect them as a unit.

  1. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.



3. REMOVE BACK-UP LIGHT BULB


    E235375
  1. Turn the rear combination light socket and wire sub-assembly with the back-up light bulb in the direction indicated by the arrow shown in the illustration and disconnect them as a unit.

  1. Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.



4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    E235379
  1. Disengage the 2 clamps.

  1. Disconnect the connector and remove the rear combination light socket and wire sub-assembly.



5. REMOVE REAR BUMPER UPPER RETAINER


    E235380
  1. Using a screwdriver, disengage the claw and remove the rear bumper upper retainer.



6. REMOVE REAR COMBINATION LIGHT GASKET


    E235381
  1. Remove the rear combination light gasket.

    NOTICE:
    1. Be sure to remove all the traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light gasket to prevent water ingress.



7. REMOVE REAR COMBINATION LIGHT CLIP


    E235382
  1. Remove the 2 rear combination light clips.