NAVIGATION SYSTEM (for Radio and Display Type) > Microphone Circuit between Radio Receiver and Extension Module |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE) |
Disconnect the radio and display receiver assembly connector.
Disconnect the extension module connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z23-19 (MIC+) - z21-9 (MIC+) | Always | Below 1 Ω |
| z23-20 (MIC-) - z21-25 (MIC-) | Always | Below 1 Ω |
| z23-21 (SHD2) - z21-24 (SHD2) | Always | Below 1 Ω |
| z23-19 (MIC+) - Body ground | Always | 10 kΩ or higher |
| z23-20 (MIC-) - Body ground | Always | 10 kΩ or higher |
| z23-21 (SHD2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||