DTC P06A4-209 Sensor Reference Voltage "D" Circuit Low |
DTC P06A5-210 Sensor Reference Voltage "D" Circuit High |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P06A4 | 209 | VC power-supply voltage is lower than 4.2 V (1 trip detection logic) | Power management control ECU |
| P06A5 | 210 | VC power-supply voltage is higher than 5.8 V (1 trip detection logic) | Power management control ECU |
| 1.CHECK DTC OUTPUT (HV) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
| P06A4-209 or P06A5-210 only is output, or DTCs except the ones in the table below are also output. | A |
| Any of the following DTCs are also output. | B |
| DTC No. | Relevant Diagnosis |
| P0516-769 | Battery Temperature Sensor Circuit Low |
| P0517-770 | Battery Temperature Sensor Circuit High |
| P0A2C-247 | Drive Motor "A" Temperature Sensor Circuit Low |
| P0A2D-249 | Drive Motor "A" Temperature Sensor Circuit High |
| P0A38-257 | Generator Temperature Sensor Circuit Low |
| P0A39-259 | Generator Temperature Sensor Circuit High |
| P2120-152 | Throttle/Pedal Position Sensor/Switch "D" Circuit |
| P2122-104 | Throttle/Pedal Position Sensor/Switch "D" Circuit Low Input |
| P2123-105 | Throttle/Pedal Position Sensor/Switch "D" Circuit High Input |
| P2125-153 | Throttle/Pedal Position Sensor/Switch "E" Circuit |
| P2127-107 | Throttle/Pedal Position Sensor/Switch "E" Circuit Low Input |
| P2128-108 | Throttle/Pedal Position Sensor/Switch "E" Circuit High Input |
|
| ||||
| A | ||
| ||