Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P3004-133    High Voltage Power Resource

for Preparation Click here


DESCRIPTION

The power management control ECU monitors its internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunctions.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3004
133
Battery overcurrent or overload current occurs due to a malfunction in the high-voltage circuit between the hybrid system, battery and inverter.
(1 trip detection logic)
Power management control ECU

Related Data List 
DTC No.
Data List
P3004-133
  1. Power Resource IB
  2. Power Resource VB
  3. VL-Voltage before Boosting
  4. VH-Voltage after Boosting
The following items can be helpful when performing repairs:
Data List
  1. Ready Signal

INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Drive the vehicle for approximately 10 minutes according to the freeze frame data items "Vehicle Spd", "Accelerator Degree" and "Power Resource IB".

1.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P3004-133 only is output.
    A
    DTCs other than P3004-133 is output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (Click here)
A

REPLACE POWER MANAGEMENT CONTROL ECU