Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER

FRONT DOOR SPEAKER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


  1. Using an air riveter or a hand riveter, install the front No. 1 speaker assembly with 4 new rivets.


    E188467E01


    Text in Illustration 
    *1
    Riveter
    *2
    Mandrel
    *a
    INCORRECT
    -
    -

    NOTICE:
    1. Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
    2. Confirm that the rivet is seated properly against the moulding. Do not tilt the riveter when installing the rivet to the moulding. Do not leave any clearance between the rivet head and moulding.
    3. Do not leave any clearance between the moulding and door frame. Firmly hold the 2 items together while installing the rivet.

    HINT:
    If the rivet cannot be cut, pull it once and cut it.



    E188468
  1. Connect the connector.



2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B228671
  1. Engage the 9 clips and install the front door trim board sub-assembly.

  1. Install the 2 screws.

  1. Remove the 2 pieces of protective tape.



3. INSTALL COURTESY LIGHT ASSEMBLY
  1. Connect the connector.



    E189696E01
  1. Engage the claw to install the courtesy light assembly.



4. INSTALL DOOR ARMREST COVER


    B228665
  1. Install the door armrest cover.



5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
  1. Connect each connector.



    B232008
  1. Engage the 7 claws and 3 guides, and install the power window regulator switch assembly with front door armrest base panel.



6. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    B228663
  1. Connect the connector.

  1. Engage the 7 claws and 3 guides, and install the power window regulator master switch assembly with front door armrest base panel.



7. INSTALL ASSIST GRIP COVER


    B228660
  1. Engage the 6 claws, 2 clips and 3 guides, and install the assist grip cover.



8. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B228657
  1. Engage the 3 claws and install the front door inside handle bezel plug.