Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER

REAR DOOR SPEAKER > INSTALLATION

for Preparation Click here



1. INSTALL REAR SPEAKER ASSEMBLY (for 6 or 8 Speakers)


  1. Using an air riveter or a hand riveter, install the rear speaker assembly with 3 new rivets.


    E188471E01


    Text in Illustration 
    *1
    Riveter
    *2
    Mandrel
    *a
    INCORRECT
    -
    -

    NOTICE:
    1. Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
    2. Confirm that the rivet is seated properly against the moulding. Do not tilt the riveter when installing the rivet to the moulding. Do not leave any clearance between the rivet head and moulding.
    3. Do not leave any clearance between the moulding and door frame. Firmly hold the 2 items together while installing the rivet.

    HINT:
    If the rivet cannot be cut, pull it once and cut it.



    E188472
  1. Connect the connector.



2. INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)


    E188473
  1. Install the rear No. 2 speaker assembly with the 2 screws.



3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
  1. for 8 Speakers:

    1. Connect the connector.



    B228801
  1. Engage the 8 clips and install the rear door trim board sub-assembly.

  1. Install the 2 screws.

  1. Remove the protective tape.



4. INSTALL REAR DOOR ARMREST COVER


    B228795
  1. Install the rear door armrest cover.



5. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
  1. Connect the connector.



    B228793
  1. Engage the 7 claws and 2 guides, and install the rear power window regulator switch assembly with rear door armrest base panel.



6. INSTALL DOOR ASSIST GRIP COVER


    B228790
  1. Engage the 6 claws, 2 clips and 3 guides, and install the assist grip cover.



7. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG


    B228786
  1. Engage the 3 claws and install the rear door inside handle bezel plug.