Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER

REAR DOOR SPEAKER > REMOVAL

for Preparation Click here



1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    B228784
  1. Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel plug.



2. REMOVE DOOR ASSIST GRIP COVER


    B228789
  1. Using a moulding remover, disengage the 6 claws, 2 clips and 3 guides, and remove the door assist grip cover.



3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    B228793
  1. Disengage the 7 claws and 2 guides.

  1. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.



4. REMOVE REAR DOOR ARMREST COVER


    B228795
  1. Remove the rear door armrest cover.



5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B228797E01
  1. Put protective tape around the rear door panel.
    Text in Illustration 
    *1
    Protective Tape



    B228799
  1. Remove the 2 screws.

  1. Using a clip remover, disengage the 8 clips.

  1. Pull out the rear door trim board sub-assembly in the direction indicated by the arrow in the illustration.

  1. Raise the rear door trim board sub-assembly and remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.



    B228803
  1. Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

  1. for 8 Speakers:

    1. Disconnect the connector.



6. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)


    E188473
  1. Remove the 2 screws and rear No. 2 speaker assembly.



7. REMOVE REAR SPEAKER ASSEMBLY (for 6 or 8 Speakers)


    E188470
  1. Disconnect the connector.

  1. Using a drill bit with a diameter of less than 4 mm (0.158 in.), drill out the 3 rivet heads and remove the rear speaker assembly.

    NOTICE:
    1. Do not touch the cone part of the speaker.
    2. Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
    3. Be careful as the cut rivet will be very hot.

  1. Continue drilling and push out the remaining rivet fragments.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.