TELEPHONE MICROPHONE (w/o Sliding Roof) > REMOVAL |
| 1. REMOVE ROOF TOP MOULDING (w/o Lane Keeping Assist System) |
![]() |
Using a moulding remover, disengage the 3 claws and 2 clips, and remove the roof top moulding.
| 2. REMOVE ROOF TOP MOULDING (w/ Lane Keeping Assist System) |
![]() |
Disengage the claw <A> as shown in the illustration.
Disengage the 2 claws <B> as shown in the illustration.
![]() |
Disengage the 3 claws and remove the roof top moulding.
| 3. REMOVE MAP LIGHT ASSEMBLY |
![]() |
Disengage the 4 clips and 2 guides as shown in the illustration.
Disconnect the connector and remove the map light assembly.
| 4. REMOVE TELEPHONE MICROPHONE ASSEMBLY |
![]() |
Remove the 6 screws and map light base.
![]() |
Disconnect the connector.
Disengage the 2 claws and remove the telephone microphone assembly.