Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TELEVISION CAMERA

TELEVISION CAMERA > INSTALLATION

for Preparation Click here



1. INSTALL REAR TELEVISION CAMERA ASSEMBLY


    E192622
  1. Engage the 4 claws to temporarily install the rear television camera assembly.



    E189835
  1. Install the rear television camera assembly with the 2 screws.



    E189834
  1. Connect the connector.



2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    B247809E01
  1. Wind double-sided tape around a string as shown in the illustration.

    HINT:
    The string is used to prevent the edge of the No. 2 back window lower moulding from being tucked under the back door outside garnish sub-assembly during installation.

    Text in Illustration 
    *1
    String
    *2
    Double-sided Tape
    *3
    Center line
    Standard Dimension 
    a
    1600.0 mm (62.992 in.)
    b
    50.0 to 75.0 mm (1.969 to 2.953 in.)
    c
    30.0 mm (1.181 in.)



    B247810E01
  1. Lift the ends of the No. 2 back window molding lower, and attach each end to the back door glass with tape.
    Text in Illustration 
    *1
    String
    *2
    Double-sided Tape
    *3
    No. 2 back window lower moulding
    *4
    Tape
    Standard Dimension 
    a
    40.0 mm (1.575 in.)

  1. Make a loop in the center of the string, and attach it to the back of the No. 2 back window lower moulding with the double-sided tape on the string.

  1. Attach the loop and ends of the string to the back door glass with tape as shown in the illustration.

  1. Install the 4 new gaskets to the back door outside garnish sub-assembly.

  1. Install 11 new clips (back door outside garnish clip) to the back door outside garnish sub-assembly.



    B229357
  1. Engage the 11 clips to install the back door outside garnish sub-assembly.

    HINT:
    Make sure that the string does not get pulled out from the back of the No. 2 back window molding lower.



    B229355
  1. Install the 4 nuts.

  1. Apply soapy water to the No. 2 back window molding lower.



    B247812E01
  1. Remove the string by slowly pulling out toward each end from the center toward the sides of the vehicle as shown in the illustration.

    NOTICE:
    Do not damage the No. 2 back window lower moulding.

  1. Check that the No. 2 back window molding lower is not pinched between the back door and the back door outside garnish sub-assembly.

  1. Remove the tape.



3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


    B227902
  1. Engage the 11 clips and 2 claws to install the back door panel trim assembly.