MAIN BODY ECU > INSTALLATION |
| 1. INSTALL MAIN BODY ECU |
![]() |
Insert the main body ECU up to the position it contacts the housing sidewall of the guide as shown in the illustration.
| *1 | Housing Sidewall |
| *a | 20° |
![]() |
Slide the guide of the main body ECU along the housing sidewall so that it contacts junction block fuses as shown in the illustration.
| *1 | Housing Sidewall |
| *2 | Junction Block Fuse |
![]() |
While contacting the main body ECU to side A of the junction block (point of rotation), rotate it downward as shown in the illustration.
| *1 | Side A Contact Portion |
![]() |
Press the push area until the claw engages to install the main body ECU.
| *1 | Push Area |
| 2. INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY |
![]() |
Engage the claw to install the connector as shown in the illustration.
![]() |
Engage the claw to lock the connector lock as shown in the illustration.
![]() |
Engage the claw to connect the connector as shown in the illustration.
![]() |
Engage the 2 clamps to connect the wire harness.
![]() |
Engage the 6 claws to install the junction block cover.
![]() |
Install the driver side junction block assembly with the bolt and nut.
![]() |
Engage the 2 claws to connect the 2 connectors (5) and (4) as shown in the illustration.
Connect the 3 connectors (3), (2) and (1) as shown in the illustration.
Engage the clamp to connect the wire harness.
| 3. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY |
| 4. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY |