RELAY (w/ Headlight Cleaner System) > REMOVAL |
| 1. REMOVE RADIATOR SUPPORT OPENING COVER |
![]() |
Remove the 3 clips.
Disengage the 2 claws and remove the radiator support opening cover.
| 2. REMOVE FRONT BUMPER ASSEMBLY |
![]() |
Put protective tape around the front bumper assembly.
| *1 | Protective Tape |
![]() |
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
![]() |
Remove the screw.
w/o Front Spoiler:
![]() |
Using a clip remover, remove the 7 clips.
Remove the 2 bolts.
![]() |
Remove the 4 screws
w/ Front Spoiler:
![]() |
Using a clip remover, remove the clip.
Remove the 6 bolts and 6 screws, and front spoiler cover.
![]() |
Remove the 2 bolts.
Using a clip remover, remove the 7 clips.
![]() |
Disengage the 3 claws and remove the front bumper assembly.
![]() |
Pull back the side of the front bumper assembly as shown in the illustration and disconnect the connector.
w/ Headlight Cleaner System:
![]() |
Disconnect the headlight cleaner hose and drain the washer fluid.
![]() |
Remove the front bumper assembly as shown in the illustration.
| 3. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 4. REMOVE HEADLIGHT CLEANER CONTROL RELAY |
![]() |
Disengage the clip and separate the washer jar cap of the washer jar assembly.
![]() |
Disconnect the 2 connectors.
Disengage the clamp.
Remove the 2 bolts.
![]() |
Disengage the hose clamp.
Disconnect the 2 washer hoses, and drain the washer fluid.
![]() |
Disconnect the 2 connectors.
Disengage the clamp.
Remove the bolt and the washer jar assembly.
![]() |
Disengage the claw and remove the headlight cleaner control relay as shown in the illustration.