Home › Audio / Visual / Telematics › CELLULAR COMMUNICATION › SAFETY CONNECT SYSTEM

SAFETY CONNECT SYSTEM > GREEN AND RED INDICATORS BLINK SIMULTANEOUSLY

for Preparation Click here


DESCRIPTION

After the power switch on (IG), the DCM (Telematics Transceiver) will enter into a self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn off followed by the manual (SOS) switch green indicator illuminating and remaining on under normal operation.
If both indicators illuminate and begin to blink simultaneously, this indicates that the DCM (Telematics Transceiver) is in "Shipping Mode." If no DTCs are present, both the green and red indicators will turn off after blinking. The activation sequence must be performed.

HINT:
In shipping mode, the system will attempt to activate to shell mode automatically at each power switch on (IG).


INSPECTION PROCEDURE

1.CHANGE SUBSCRIPTION MODE
  1. Turn the power switch on (IG).

  1. Push the manual (SOS) switch.

  1. The vehicle will issue a voice prompt: "Safety Connect is not initialized. To activate, please press the button again within 5 seconds."

  1. Push the manual (SOS) switch and a beep will be emitted.

  1. That telematics service provider will send an End Call command and the manual (SOS) switch green indicator will illuminate.

  1. A voice prompt will state: "Activation Complete" (This may take up to 3 minutes)

  1. Turn the power switch off.


NEXT


2.CHECK SUBSCRIPTION MODE
  1. Turn the power switch on (IG).

  1. Confirm the manual (SOS) switch red indicator illuminates for 2 seconds and turns off and the manual (SOS) switch green indicator illuminates and remains on (Click here).


NEXT

END