VACUUM SENSOR > REMOVAL |
| 1. REMOVE NO. 2 CYLINDER HEAD COVER |
![]() |
Remove the 3 clips and No. 2 cylinder head cover.
| 2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the connector.
![]() |
Loosen the hose clamp and disconnect the air cleaner hose assembly.
Remove the 2 clamps and air cleaner cap subassembly.
| 3. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 4. REMOVE AIR CLEANER CASE |
Remove the air cleaner filter element sub-assembly.
![]() |
Separate the hose from the 3 clamps.
Remove the 3 bolts and air cleaner case.
| 5. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR |
![]() |
Disconnect the connector.
Remove the bolt and manifold absolute pressure sensor.