Home › Vehicle Interior › HEATING / AIR CONDITIONING › SOLAR VENTILATION SYSTEM

SOLAR VENTILATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the solar ventilation system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Inspect the battery voltage with the power switch off.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    3.CHECK FOR DTC*
    1. Check for DTCs and note any code that is output.

    2. Clear the DTCs.

    3. Recheck for DTCs.

      Result:

      Result
      Proceed to
      DTC is not output.
      A
      DTC is output.
      B



    B.
    GO TO RELEVANT SYSTEM
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:

      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B



    B.
    Go to step 5
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)

    3. Operation Check (Click here)

    4. Inspection


    NEXT


    6.ADJUST, REPAIR OR REPLACE

      NEXT

      END