Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR

FRONT SPEED SENSOR > REMOVAL

for Preparation Click here


NOTICE:
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or open/ close the doors while the auxiliary battery is connected.

HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The following procedure is for the LH side.
  3. If the sensor rotor needs to be replaced, replace it together with the front axle hub and bearing assembly.



1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



2. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



3. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL


5. REMOVE FRONT WHEEL


6. REMOVE FRONT FENDER LINER


    C208383
  1. Remove the 12 clips, 4 screws, 3 grommets, and front fender liner.

    HINT:
    Use the same procedure for the RH side and LH side.



7. REMOVE FRONT SPEED SENSOR


    C208046
  1. Remove the 2 clamps and disconnect the front speed sensor connector.



    C208048E01
  1. Remove the bolt and No. 2 sensor clamp from the body.
    Text in Illustration 
    *1
    No. 2 Sensor Clamp



    C208047E01
  1. Remove the bolt, No. 1 sensor clamp and front brake flexible hose together from the shock absorber assembly.
    Text in Illustration 
    *1
    No. 1 Sensor Clamp
    *2
    Front Brake Flexible Hose

  1. Remove the clamp from the shock absorber assembly.



    C208049
  1. Remove the bolt and front speed sensor.

    NOTICE:
    1. Prevent foreign matter from attaching to the front speed sensor tip.
    2. Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.