Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF INDICATOR LIGHT

AIRBAG CUT-OFF INDICATOR LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL PASSENGER SEAT BELT WARNING LIGHT ASSEMBLY


    B228035
  1. Engage the 2 claws to install the passenger seat belt warning light assembly.



2. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Connect the connector.

  1. Engage the 7 claws.

  1. Install the center instrument cluster finish panel garnish with the 2 screws <C>.



3. INSTALL GLOVE COMPARTMENT DOOR
  1. Open the glove compartment door assembly.



    B223486
  1. Insert the glove compartment door as shown in the illustration.

  1. Engage the 7 claws to install the glove compartment door.



4. INSTALL NO. 2 INSTRUMENT PANEL REGISTER


    B223484
  1. Engage the 3 claws and clip to install the No. 2 instrument panel register.



5. INSTALL NO. 1 SIDE DEFROSTER NOZZLE


    B223481
  1. Engage the 3 claws to install the No. 1 side defroster nozzle.



6. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
w/ Daytime Running Light:
w/o Daytime Running Light:


7. INSTALL NAVIGATION RECEIVER WITH BRACKET (for Navigation Receiver Type)


    E188508
  1. Engage the 4 claws and temporarily install the navigation receiver with bracket as shown in the illustration.

  1. Install the navigation receiver with bracket with the 4 bolts.



8. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
  1. Connect the connector.

  1. Engage the 3 claws to install the upper instrument panel finish panel sub-assembly.



9. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Connect the connector.

  1. Engage the 14 claws to install the instrument cluster finish panel garnish.



10. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B223456
  1. Engage the 7 claws and 2 clips to install the lower center instrument cluster finish panel sub-assembly.



11. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY


    B223453
  1. Connect each connector.

  1. Engage the 6 claws to install the integration control and panel assembly.



12. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL


13. INSTALL REAR NO. 3 FLOOR BOARD


    B227791
  1. Engage the 2 guides to install the rear No. 3 floor board.



14. INSTALL REAR DECK FLOOR BOX
  1. Install the rear deck floor box.



15. INSTALL REAR NO. 2 FLOOR BOARD


    B227788E01
  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.



16. PERFORM DIAGNOSTIC SYSTEM CHECK
  1. Perform a diagnostic system check (Click here).



17. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).