Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION BRAKE CANCEL SWITCH

PRE-COLLISION BRAKE CANCEL SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL PRE-COLLISION SYSTEM CANCEL SWITCH ASSEMBLY


    E188650
  1. Engage the 2 claws to install the pre-collision system cancel switch assembly.



2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Connect each connector.

  1. Engage the guide and claw.

  1. Install the No. 1 instrument panel under cover sub-assembly with the 2 screws <D>.