Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION BRAKE CANCEL SWITCH

PRE-COLLISION BRAKE CANCEL SWITCH > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B223658
  1. Remove the 2 screws <D>.

  1. Disengage the claw and guide.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.



2. REMOVE PRE-COLLISION SYSTEM CANCEL SWITCH ASSEMBLY


    E188650
  1. Disengage the 2 claws and remove the pre-collision system cancel switch assembly.