Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSPECTION

for Preparation Click here



1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


    B230726E04
  1. Inspect outer mirror motor operation.

    1. Apply battery voltage and check the operation of the mirror face, as shown in the table and illustration.

      OK:
      Connection
      Result
      Battery positive (+) → Terminal 5 (MV)
      Battery negative (-) → Terminal 4 (M+)
      Turns upward
      Battery positive (+) → Terminal 4 (M+)
      Battery negative (-) → Terminal 5 (MV)
      Turns downward
      Battery positive (+) → Terminal 3 (MH)
      Battery negative (-) → Terminal 4 (M+)
      Turns left
      Battery positive (+) → Terminal 4 (M+)
      Battery negative (-) → Terminal 3 (MH)
      Turns right

      Text in Illustration 
      *a
      Front view of wire harness connector
      (to Outer Rear View Mirror Assembly LH)
      If the result is not specified, replace the outer rear view mirror assembly.

  1. Check the mirror heater (w/ Mirror heater).

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Terminal 1 (HL+) - Terminal 2 (HL-)
      25°C (77°F)
      7.6 to 11.4 Ω

      If the result is not specified, replace the outer rear view mirror assembly.



2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH


    B230725E04
  1. Inspect outer mirror motor operation.

    1. Apply battery voltage and check the operation of the mirror face, as shown in the table and illustration.

      OK:
      Connection
      Result
      Battery positive (+) → Terminal 5 (MV)
      Battery negative (-) → Terminal 4 (M+)
      Turns upward
      Battery positive (+) → Terminal 4 (M+)
      Battery negative (-) → Terminal 5 (MV)
      Turns downward
      Battery positive (+) → Terminal 3 (MH)
      Battery negative (-) → Terminal 4 (M+)
      Turns left
      Battery positive (+) → Terminal 4 (M+)
      Battery negative (-) → Terminal 3 (MH)
      Turns right

      Text in Illustration 
      *a
      Front view of wire harness connector
      (to Outer Rear View Mirror Assembly RH)
      If the result is not specified, replace the outer rear view mirror assembly.

  1. Check the mirror heater (w/ Mirror heater).

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Terminal 1 (HR+) - Terminal 2 (HR-)
      25°C (77°F)
      7.6 to 11.4 Ω

      If the result is not specified, replace the outer rear view mirror assembly.