Home › Vehicle Exterior › MIRROR (EXT) › OUTER MIRROR SWITCH

OUTER MIRROR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT OUTER MIRROR SWITCH ASSEMBLY


    B298052E03
  1. Inspect the outer mirror switch assembly.

    1. Measure the resistance according to the value(s) in the table below when the outer mirror switch assembly is operated.

      HINT:
      Select "L" on the left/right adjustment switch.

      Tester Connection
      Switch Condition
      Specified Condition
      9 (VL) - 13 (B)
      Up
      Below 1 Ω
      11 (M+) - 12 (E)
      9 (VL) - 12 (E)
      Down
      11 (M+) - 13 (B)
      10 (HL) - 13 (B)
      Left
      11 (M+) - 12 (E)
      10 (HL) - 12 (E)
      Right
      11 (M+) - 13 (B)

      HINT:
      Select "R" on the left/right adjustment switch.
      Tester Connection
      Switch Condition
      Specified Condition
      8 (VR) - 13 (B)
      Up
      Below 1 Ω
      11 (M+) - 12 (E)
      8 (VR) - 12 (E)
      Down
      11 (M+) - 13 (B)
      7 (HR) - 13 (B)
      Left
      11 (M+) - 12 (E)
      7 (HR) - 12 (E)
      Right
      11 (M+) - 13 (B)
      Text in Illustration 
      *a
      Component without harness connected
      (Outer Mirror Switch Assembly)

      If the result is not as specified, replace the outer mirror switch assembly.



  1. Check the LED illuminates.



      B298052E01
    1. Auxiliary battery voltage to the outer mirror switch assembly and check that the LED illuminates.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 6 (ILL+)
      Battery negative (-) → Terminal 16 (ILL-)
      LED illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Outer Mirror Switch Assembly)
      If the result is not as specified, replace the outer mirror switch assembly.