Home › Vehicle Interior › SEAT › LUMBAR SWITCH

LUMBAR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER SEAT SWITCH ASSEMBLY


    B239575E11
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Hold Switch
    *2
    Release Switch
    *a
    Component without harness connected
    (Power Seat Switch Assembly)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 5
    Hold
    Below 1 Ω
    1 - 2
    3 - 2
    Off
    1 - 2
    3 - 2
    Release
    1 - 5

    If the result is not as specified, replace the power seat switch assembly.