Home › Vehicle Exterior › LIGHTING (EXT) › FRONT TURN SIGNAL LIGHT ASSEMBLY

FRONT TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER ASSEMBLY
(Click here)


2. REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY (w/o Daytime Running Light)


    E238379
  1. Disconnect the connector.

  1. Disengage each clamp.

  1. Remove the clip.

  1. Using a screwdriver, disengage the 2 claws and remove the front turn signal light assembly.



3. REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY (w/ Daytime Running Light)


    E238383
  1. Disconnect the connector.

  1. Disengage each clamp.

  1. Remove the clip.

  1. Using a screwdriver, disengage the 2 claws and remove the front turn signal light assembly.



4. REMOVE FRONT TURN SIGNAL LIGHT BULB (w/o Daytime Running Light)


    E235362
  1. Turn the front turn signal light plug assembly with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the front turn signal light bulb from the front turn signal light plug assembly.



5. REMOVE FRONT TURN SIGNAL LIGHT BULB (w/ Daytime Running Light)


    E238385
  1. Turn the socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.

  1. Remove the front turn signal light bulb from the socket.



6. REMOVE NO. 1 FRONT TURN SIGNAL LIGHT BRACKET


    E238387E01
  1. Remove the screw.
    Text in Illustration 
    *A
    w/o Daytime Running Light
    *B
    w/ Daytime Running Light

  1. Using a screwdriver, disengage the claw and guide, and remove the No. 1 front turn signal light bracket.



7. REMOVE NO. 2 FRONT TURN SIGNAL LIGHT BRACKET


    E238389E01
  1. Remove the screw.
    Text in Illustration 
    *A
    w/o Daytime Running Light
    *B
    w/ Daytime Running Light

  1. Using a screwdriver, disengage the claw and guide, and remove the No. 2 front turn signal light bracket.



8. REMOVE NO. 3 FRONT TURN SIGNAL LIGHT BRACKET (w/o Daytime Running Light)


    E235368
  1. Remove the 2 screws.

  1. Disengage the 3 guides and remove the No. 3 front turn signal light bracket.



9. REMOVE NO. 3 FRONT TURN SIGNAL LIGHT BRACKET (w/ Daytime Running Light)


    E238391E01
  1. Disengage the 2 clamps and disconnect the wire harness.
    Text in Illustration 
    *1
    Clamp
    *2
    Guide

  1. Remove the 2 screws.

  1. Disengage the 3 guides and remove the No. 3 front turn signal light bracket.