Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1D-187    Hybrid Powertrain Control Module

for Preparation Click here


DESCRIPTION

The power management control ECU (HV CPU) monitors its internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunctions. If any of the following DTCs are output, replace the power management control ECU (HV CPU).

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1D
187
ECU internal error
(1 trip detection logic)
Power management control ECU

MONITOR DESCRIPTION

The power management control ECU (HV CPU) performs diagnostic tests to verify proper operation of internal and external ECU systems. In one of these tests, the power management control ECU (HV CPU) monitors specific RAM circuits of the power management control ECU (HV CPU). If the power management control ECU (HV CPU) detects an error in the RAM circuits, it will conclude that there is an internal malfunction in the power management control ECU (HV CPU). The power management control ECU (HV CPU) will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A1D (INF 187): Specific random access memory destruction
Required sensors / components
Power management control ECU (HV CPU)
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Power management control ECU (HV CPU)
DTC P0A1D (INF 187) is not detected

CONFIRMATION DRIVING PATTERN


A218446E01

  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off and wait for 30 seconds or more.
  5. Turn the power switch on (READY) and after a few seconds, turn the power switch off. [A]
  6. Repeat [A] 3 times. [B]
  7. Turn the power switch on (IG) and turn the Techstream on.
  8. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes. [C]
  9. Read the current DTCs.

    HINT:
    1. If a current DTC is output, the system is malfunctioning.
    2. If a current DTC is not output and want to confirm permanent DTC, perform the following procedure.

  10. Check that permanent DTCs are cleared.
  11. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.

INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Turn the power switch on (IG) and wait for 30 seconds or more.

1.REPLACE POWER MANAGEMENT CONTROL ECU
  1. Replace the power management control ECU (Click here).


NEXT

COMPLETED