Home › Vehicle Exterior › MIRROR (EXT) › POWER MIRROR CONTROL SYSTEM

POWER MIRROR CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Air Conditioner / Active Test.

  5. Perform the Active Test according to the display on the Techstream.

    Air Conditioner 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Mirror Heater Relay
    Mirror Heater
    ON/OFF
    -