STEERING GEAR > REASSEMBLY |
| 1. INSTALL STEERING RACK BOOT LH |
![]() |
Apply lithium soap base glycol grease to the inside of the small opening of a new steering rack boot LH.
Install the steering rack boot LH to the groove on the rack housing.
| 2. INSTALL STEERING RACK BOOT RH |
| 3. INSTALL NO. 2 STEERING RACK BOOT CLAMP |
![]() |
Using SST, tighten a new No. 2 steering rack boot clamp, as shown in the illustration.
| 4. INSTALL NO. 1 STEERING RACK BOOT CLAMP |
| 5. INSTALL STEERING RACK BOOT CLIP LH |
Using pliers, install the steering rack boot clip LH.
| 6. INSTALL STEERING RACK BOOT CLIP RH |
| 7. INSPECT STEERING GEAR ASSEMBLY |
![]() |
Using SST, rotate the pinion shaft to see if both the left and the right steering rack boots expand and contract smoothly.