POWER WINDOW CONTROL SYSTEM > CUSTOMIZE PARAMETERS |
| 1. CUSTOMIZE POWER WINDOW CONTROL SYSTEM |
Customizing with the Techstream
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Customize Setting / Power Window.
Select the setting by referring to the table below.
| Tester Display | Default | Content | Setting | Relevant ECU |
| P Window Auto Up | Avail | This function is used to enable or disable the auto up function for the front passenger door window using the power window regulator switch assembly (for front passenger door). | Not Avl/Avail | Power window ECU (Power window regulator motor assembly) |
| P Window Auto Up From Driver | Avail | This function is used to enable or disable the remote auto up function for the front passenger door window using the multiplex network master switch assembly. | Not Avl/Avail | Power window ECU (Power window regulator motor assembly) |
| RR Window Auto Up | Avail | This function is used to enable or disable the auto up function using the power window regulator switch assembly (for rear RH door). | Not Avl/Avail | Power window ECU (Power window regulator motor assembly) |
| RR Window Auto Up From Driver | Avail | This function is used to enable or disable the remote auto up function for the rear RH door window using the multiplex network master switch assembly. | Not Avl/Avail | Power window ECU (Power window regulator motor assembly) |
| RL Window Auto Up | Avail | This function is used to enable or disable the auto up function using the power window regulator switch assembly (for rear LH door). | Not Avl/Avail | Power window ECU (Power window regulator motor assembly) |
| RL Window Auto Up From Driver | Avail | This function is used to enable or disable the remote auto up function for the rear LH door window using the multiplex network master switch assembly. | Not Avl/Avail | Power window ECU (Power window regulator motor assembly) |