AUDIO AND VISUAL SYSTEM (w/o Daytime Running Light) > PRECAUTION |
| 1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 2.PRECAUTIONS FOR RADIO AND DISPLAY RECEIVER ASSEMBLY |
A Hard Disk Drive (HDD) is built into the radio and display receiver assembly to store multi-media data, and is used for the audio and visual system. Therefore, care must be taken for the following points when handling:

When it is necessary to replace the navigation ECU sub-assembly, be sure to replace it with a new one.
Do not apply any vibration or shock to the radio and display receiver assembly.
Do not remove the radio and display receiver assembly if there is a risk that condensation may occur.
Take measures to prevent static electricity.
Keep the radio and display receiver assembly away from magnets or magnetized items.
| 3.PRECAUTIONS FOR HARD DISK DRIVE (HDD) |
Multi-media data for the audio and visual system is stored on the Hard Disk Drive (HDD). Make sure to follow the following instructions when replacing the HDD:
The HDD must only be replaced with a new one. Do not attempt to install a used HDD from another vehicle.
![]() |
Do not touch the HDD cover.
Do not apply any vibration or shock to the HDD.
Do not remove the HDD if there is a risk that condensation may occur.
Take measures to prevent static electricity.
Keep the HDD away from magnets or magnetized items.
Inspect after HDD replacement.