Home › Drivetrain › P410 HYBRID TRANSMISSION / TRANSAXLE › HYBRID VEHICLE TRANSAXLE UNIT

HYBRID VEHICLE TRANSAXLE UNIT > INSPECTION

for Preparation Click here



1. INSPECT INPUT SHAFT ASSEMBLY END PLAY


    C269194E01
  1. Using SST and a dial indicator, measure the input shaft assembly end play.

    SST
    09951-01600  

    Standard End Play:
    0.10 to 0.20 mm (0.00394 to 0.00787 in.)

    If the value is not as specified, replace the planetary sun gear snap ring with one of the correct thickness.



2. INSPECT NO. 1 REAR PLANETARY GEAR ASSEMBLY


    C269733
  1. Using a feeler gauge, measure the clearance between the No. 1 rear planetary gear assembly and the pinion gear.

    Standard Clearance:
    0.11 to 0.91 mm (0.00433 to 0.0358 in.)

    If the value is not as specified, replace the No. 1 rear planetary gear assembly.