Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM

SEAT HEATER SYSTEM > OPERATION CHECK

for Preparation Click here



CHECK THE THERMOSTAT IN THE FRONT SEAT CUSHION HEATER
  1. Remove the front seat cushion heater (Click here). (for Manual Seat Type RH Side)

  2. Remove the front seat cushion heater (Click here). (for Power Seat)

  3. Remove the front seatback heater (Click here). (for Manual Seat Type RH Side)

  4. Remove the front seatback heater (Click here). (for Power Seat)



  5. Connect the B front seat cushion heater connector and C front seatback heater connector.


    B343005E01


    Text in Illustration 
    *A
    for Power Seat
    *B
    for Manual Seat Type RH Side
    *a
    Component with harness connected
    (Front Seat Cushion Heater)
    *b
    Component with harness connected
    (Front Seatback Heater)

  6. Apply battery voltage and check operation of the front seat heater as shown in the table below.

    NOTICE:
    To prevent the front seat heater from overheating, be sure to disconnect the battery from the front seat heater immediately after this inspection is completed.


    OK:
    for Manual Seat Type RH Side 
    Connection
    Specified Condition
    Battery positive (+) → Terminal A-6
    Battery negative (-) → Terminal A-5
    Front seat heater temperature 37 to 39°C (98 to 102°F)
    for Power Seat 
    Connection
    Specified Condition
    Battery positive (+) → Terminal A-1
    Battery negative (-) → Terminal A-2
    Front seat heater temperature 37 to 39°C (98 to 102°F)