FRONT BODY PILLAR > CUT AND JOIN REPLACEMENT SECTIONS



  1. K104257
    With the cowl top side upper panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100015
Remove Weld Points
K100016
Remove Weld Points
K100022
Cut with Disc Sander etc.
K100023
Cut and Join Location
K100024
Cut Location for Supply Parts
REMOVAL POINT
  1. *1 is reused.

K102781E01


K102782E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100020
Plug Weld
K100021
Plug Weld
K100023
Cut and Join Location
K100026
Fillet Weld
K100027
Butt Weld
K100030
Body Sealer
INSTALLATION POINT
  1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
  2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  3. If the entire supply part is not needed, remove the part of the supply part that is needed.
  4. Before installing a new part, apply body sealer.

    HINT:
    Apply body sealer in an even, continuous bead.

  5. Before temporarily installing the new parts, weld the rocker reinforce sub-assembly outer, front body pillar sub-assembly inner and front pillar reinforcement sub-assembly lower with the standard number of welding points.
  6. When welding *1, make a hole on a new part for plug welding and weld the panel with the panel.
  7. After welding the rocker reinforce sub-assembly outer, front body pillar sub-assembly inner and front pillar reinforcement sub-assembly lower to the vehicle side, install the front body pillar outer and *2.
  8. After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)
  9. After welding, apply body sealer to the corresponding parts. (See the painting / coating)
  10. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K102783E01


K102784E01


K102785E01