NAME PLATE > ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    HINT:
    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    NOTICE:
    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    HINT:
    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.


Text in Illustration 
*1
Profile of Back Door Panel
-
-

Reference Value 
Area
Measurement
Area
Measurement
*a
149.9 mm (5.90 in.)
*b
167.1 mm (6.58 in.)
*c
150.3 mm (5.92 in.)
*d
329.8 mm (1.08 ft.)
*e
146.6 mm (5.77 in.)
*f
329.5 mm (1.08 ft.)
*g
151.1 mm (5.95 in.)
*h
219.3 mm (8.63 in.)
*i
149.5 mm (5.89 in.)
-
-

B310564E01


K104777E01