MONITOR SYSTEM > DETAILS



FUNCTION OF MAIN COMPONENTS
  1. The rear view monitor system consists of the following parts:

    Component
    Function
    Rear Television Camera Assembly
    Captures images in rear of the vehicle and outputs visual signals to the navigation system's head unit.


FUNCTION


  1. Area Displayed on Screen

    1. On the display, objects on the right of the vehicle appear on the right side of the display panel, and objects on the left of the vehicle appear on the left side of the display panel.



    2. The rear television camera assembly uses a wide-angle lens. The perceived distance from images that appear on the screen differs from the actual distance.


      Y118341

      HINT:
      Area displayed on screen may vary according to vehicle status or road conditions. The area covered by the rear television camera assembly is limited. The rear television camera assembly dose not show objects close to either corner of the bumper or under bumper.


CONSTRUCTION


  1. Rear Television Camera Assembly

    1. The rear television camera assembly consists of a wide-angle lens and a Complementary Metal Oxide Semiconductor (CMOS).

    2. An image captured by the rear television camera assembly lens is converted into electrical signals according to the light intensity by using the CMOS image element, and the signals are then output to the navigation system's head unit.



    3. The image output from the rear television camera assembly is reversed to much the rear view seen from the inner rear view mirror assembly. Therefore, the rear view actually seen is displayed on the screen in the horizontal reverse.


      Y118342E01


      Text in Illustration 
      *1
      Wide-angle Lens
      -
      -