FEATURES > PERFORMANCE



OUTLINE


  1. TOYOTA Hybrid System-II (THS-II)



    1. This system optimally performs cooperative control of the 1NZ-FXE engine, and Motor Generator No. 1 (MG1) and Motor Generator No. 2 (MG2) in the P510 hybrid vehicle transaxle assembly that provides excellent transmission performance. Furthermore, this system uses a high-output HV battery with a nominal voltage of DC 144 V, and a variable-voltage system in which a boost converter boosts the operating voltage of the system to a maximum voltage of DC 520 V.


      V100884E01


      Text in Illustration 
      *1
      1NZ-FXE Engine
      *2
      Inverter with Converter Assembly
      *3
      HV Battery Assembly
      *4
      P510 Hybrid Vehicle Transaxle Assembly

      System Performance 
      Maximum System Output*
      kW
      73.6
      *: Maximum system output is engine output and MG2 output controlled by THS-II. MG2 output depends on power supplied by the HV battery.



  2. 1NZ-FXE Engine

    1. The 1NZ-FXE is an in-line 4-cylinder, 1.5-liters, 16-valve DOHC engine.



    2. This engine uses a high-expansion ratio Atkinson cycle, Variable Valve Timing-intelligent (VVT-i) system, Electric Throttle Control System-intelligent (ETCS-i) and Exhaust Gas Recirculation (EGR) system employing a highly efficient EGR cooler. In addition, use of an electric engine water pump assembly has eliminated the V-ribbed belt. Thus, improved engine performance, quietness, fuel economy, and cleaner emissions have been achieved.


      V103003


      Item
      Specification
      No. of Cyls. & Arrangement
      4-cylinder, In-line
      Valve Mechanism
      16-valve, DOHC with VVT-i
      Fuel System
      SFI
      Displacement
      cm3 (cu. in.)
      1497 (91.3)
      Max. Output (SAE-NET)*
      kW @ rpm
      54 @ 4800
      Max. Torque (SAE-NET)*
      N*m @ rpm
      111 @ 3600 - 4400
      1. *: Maximum output and torque rating are determined using the revised SAE J1349 procedure.



  3. P510 Hybrid Vehicle Transaxle Assembly



    1. The P510 hybrid vehicle transaxle assembly contains Motor Generator No. 1 (MG1) and Motor Generator No. 2 (MG2).


      V102230E01


      Text in Illustration 
      *1
      Motor Generator No. 2 (MG2)
      *2
      Motor Generator No. 1 (MG1)

      Item
      Specification
      Motor Generator No. 1 (MG1)
      Motor Generator No. 2 (MG2)
      Type
      Permanent Magnet Motor
      Permanent Magnet Motor
      Function
      Generate, Engine Starter
      Generate, Drive Wheels
      Cooling System
      Air-cooled
      Air-cooled
      Maximum Output
      kW
      -
      45
      Maximum Torque
      N*m
      -
      169



  4. Suspension

    1. A MacPherson strut type independent suspension is used for the front.



    2. A torsion-beam type suspension is used for the rear.


      V100883



  5. Steering



    1. An Electric Power Steering (EPS) system is used.


      V102171

  6. Tire Pressure Warning System

    1. A direct-sensing type tire pressure warning system is used for some models.

  7. Brake

    Item
    Specification
    Front Brake
    Type
    Ventilated Disc
    Rotor Size (D x T)*
    mm (in.)
    255 x 22 (10.04 x 0.87)
    Rear Brake
    Type
    Leading-trailing Drum
    Drum Inner Diameter
    mm (in.)
    228.6 (9.00)
    Brake Control System
    ABS with EBD, Brake Assist, TRC, VSC, Hill-start Assist Control
    *: Diameter x Thickness