TIRE PRESSURE WARNING SYSTEM > DETAILS |
| FUNCTION OF MAIN COMPONENTS |
| Component | Functions |
| Tire Pressure Warning Valve and Transmitter | Detects the tire inflation pressure and temperature of the tire and transmits the measured value and ID code to the tire pressure warning ECU and receiver. |
| Tire Pressure Warning ECU and Receiver |
|
| Tire Pressure Warning Reset Switch | The current tire inflation pressures are stored in the tire pressure warning ECU and receiver as set pressures when the tire pressure warning reset switch is operated. |
| Combination Meter Assembly | Transmits the vehicle speed signal to the tire pressure warning ECU and receiver. |
| Tire Pressure Warning Light | Warns the driver by illuminating or blinking for one minute in accordance with the signal from the tire pressure warning ECU and receiver. |
| Main Body ECU (Multiplex Network Body ECU) |
|
| FUNCTION |
Warning Function
The tire pressure warning ECU and receiver has 2 warning methods, depending on the condition detected.
The table below shows the warning methods for the warning light in the combination meter assembly.
| Detection Condition | Tire Pressure Warning Light |
| The tire pressure warning ECU and receiver has detected that a tire inflation pressure becomes lower than the threshold. | Illuminates*1 |
| The tire pressure warning ECU and receiver has detected a malfunction in the system. | Illuminates after blinking for 1 minute*2 |
Initial Check Function
After the power switch is tuned on (IG), the tire pressure warning ECU and receiver illuminates the tire pressure warning light for 3 seconds to check the warning light circuit.
Initialization Function
The warning threshold is calculated from the tire inflation pressure value at the time of initialization and memorized in the tire pressure warning ECU and receiver. Therefore, the tire pressure warning ECU and receiver should be initialized after:
Initialization starts after the tire pressure warning reset switch is pressed and the tire pressure warning light illuminates slowly 3 times.
Before performing initialization, adjust the tire inflation pressure to the recommended pressure when the tires are cold. For details, refer to the Repair Manual.
The tire pressure warning reset switch is not used to cancel the warning. Do not press the tire pressure warning reset switch to turn off the tire pressure warning light.
| CONSTRUCTION |
Tire Pressure Warning Valve and Transmitter
The tire pressure warning valve and transmitters are integrated in the tire valves. Each transmitter consist of a lithium battery, sensor and transmitter.
Make sure not to damage the urethane covered backside of the transmitter (the surface opposite to the side with the ID code) with anything sharp.
The transmitter directly measures tire pressure, temperature, and centrifugal acceleration.
The transmitter transmits the measured tire pressure and temperature values to the tire pressure warning ECU and receiver on a frequency of 314.98 MHz.
Depending on the timing of the data transmission, it may take several minutes to receive the data from the tire pressure warning valve and transmitter.
The ID code is written on the tire pressure warning valve and transmitter.

| *1 | Tire Pressure Warning Valve and Transmitter | *2 | Grommet |
| *3 | Washer | *4 | Nut |
| *5 | Tire Valve Core | *6 | Cap |
| *7 | Lithium Battery | *8 | Sensor and Transmitter |
| *9 | ID Code (Hexadecimal 7 Digits) | - | - |
| DIAGNOSIS |
To inform the driver when the tire pressure warning ECU and receiver detects a malfunction in the system, the tire pressure warning ECU and receiver will blink the tire pressure warning light for 1 minute, after which the light will illuminate. The tire pressure warning ECU and receiver will also store Diagnostic Trouble Codes (DTCs) in memory.
5-digit DTCs can be read by connecting the Global TechStream (GTS) to the DLC3. For details, refer to the Repair Manual.