Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE

REAR BRAKE FLEXIBLE HOSE > REMOVAL

for Preparation Click here


NOTICE:
If both the RH side hose and LH side hose are disconnected at the same time, be sure to place identification marks indicating the position on each side.

HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The following procedure listed is for the LH side.



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).



2. DISABLE BRAKE CONTROL
  1. Wait at least 2 minutes after turning the power switch off.

    NOTICE:
    When the brake pedal is depressed or the door courtesy switch is turned on even if the power switch is off, the brake control system activates. Therefore do not depress the brake pedal or open/close the doors until the reservoir level switch connector is disconnected.



    C250008
  1. Disconnect the reservoir level switch connector with the parking brake applied.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal (Click here).

  1. Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.

  1. Check that the brake pedal can not be further depressed.

  1. Release the parking brake.



3. REMOVE REAR WHEEL


4. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



5. REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR (for RH Side)


    C247550
  1. Remove the 2 nuts and front No. 4 floor heat insulator.



6. REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY (for RH Side)


    C247551
  1. Remove the clip.

  1. Remove the bolt and No. 1 fuel tank protector sub-assembly.



7. REMOVE REAR FLEXIBLE HOSE


    C163997
  1. Using a union nut wrench, disconnect the 2 brake lines while holding the rear flexible hose with a wrench.

    NOTICE:
    1. Do not kink or damage the brake line.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake line.

  1. Remove the 2 clips and rear flexible hose.