Home › Engine / Hybrid System › 1NZ-FXE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL OIL PUMP SEAL
  1. Apply MP grease to the lip of a new oil pump seal.

    NOTICE:
    Keep the lip free from foreign matter.



    A266940E01
  1. Using SST and a hammer, tap in the oil pump seal until its surface is flush with the front oil pump seal retainer edge.

    SST
    09223-22010  

    Tap in depth:
    0 to 1.0 mm from the edge of the timing chain cover.

    NOTICE:
    1. Do not tap the oil pump seal at an angle.
    2. Wipe off extra grease from the crankshaft.



2. INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY
  1. Align the hole of the crankshaft damper sub-assembly with the straight pin, then install the crankshaft damper sub-assembly.



    A266941E01
  1. Using SST, hold the crankshaft damper sub-assembly in place and tighten the bolt.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    SST
    09213-58012   (91111-50845)
    09330-00021  

    Torque:
    128 N*m{ 1305 kgf*cm , 94 ft.*lbf }

    NOTICE:
    When installing SST, be careful that the bolt which holds SST does not interfere with the timing chain cover.



3. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH


    A266934E01
  1. Temporarily install the engine mounting insulator sub-assembly RH with the 4 bolts and 2 nuts.

  1. Tighten the 3 bolts (A) in the sequence shown in the illustration.

    Torque:
    52 N*m{ 530 kgf*cm , 38 ft.*lbf }

  1. Tighten the bolt (B) and 2 nuts.

    Torque:
    52 N*m{ 530 kgf*cm , 38 ft.*lbf }



4. INSTALL NO. 2 ENGINE ROOM RELAY BLOCK AND NO. 2 JUNCTION BLOCK ASSEMBLY
  1. Install the No. 2 engine room relay block and No. 2 junction block assembly with the 2 nuts and bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



5. INSPECT FOR OIL LEAK


6. INSTALL ENGINE UNDER COVER RH


7. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }